Page 1 of 1

"quares" label

Posted: Sat Jul 16, 2011 1:09 pm
by Kazander
The default map, "dun", shows a label in the upper left corner above the "B". This label is "quares", although I'm pretty sure it actually says "Squares" and the "S" is just off the left edge of the screen.

This label doesn't show in the Unit Manager, stays around whenever you load a local map, but disappears if you load an Artpack map.

Not a huge issue, but it is strange.

Posted: Sun Jul 17, 2011 11:40 am
by heruca
Oops! How embarrassing. :oops:

That is the dynamic text label used by the "Measure Range" command. I must've compiled without resetting that label to its usual off-screen location.